Using a squirrel distress call to coax out a wary squirrel, I get a surprise visitor I received permission to hunt a little farm right outside of town, and got out to the woods a bit after day break. I worked my way back to an area in which I’d seen squirrels earlier in the year while on a pre-season scouting trip. There were several food trees and a big oak that looked like it might have a den, set in a flat area with undergrowth thinning in the early fall season. This was going to be a pleasant morning, it was a little overcast and about 60 degrees and I felt sure IÂ’d kick up a couple of bushytails before too long. I was set up under a tree with a couple of thick vines running down in front of me, offering a little bit more cover and further breaking my outline. After about twenty minutes I saw the first squirrel of the morning up in the canopy moving around, but I could not get a clear shot before I lost him in the foliage. I waited another ten minutes and saw nothing, so decided to break out a call and give it a try. I am getting better with calling as every season passes, finding that when I know thereÂ’s a squirrel in the vicinity a call will sometimes bring him out. So I started with a few barks switching over to a distress squeal, then waited. NotRead More →

From Predator International A few years back, Predator International release a new line of pellets called the Polymag, which were a hollow point pellet with a bonded polymer tip. Unlike the experience I’d had with pointed field pellets, these were fairly accurate in many of my guns. The exception being that they did not like exceedingly high powered PCP’s. But even in these cases if you had a gun with an adjustable power setting, you could dial down the power from say 30 fpe to 22 fpe of energy and often times pull the accuracy back. I used these pellets extensively for squirrel, rabbit, and medium sized quarry with good results. The terminal performance could be devastating, and I considered them a solid mid range hunting pellet, The primary disadvantage however, was that many multi-shot rifles could not cycle these pellets, they were too long and at best would jam up the magazine, and at worst (or maybe not worse, but equally unusable) would not even fit the magazine making loading impossible. As many of the rifles I use are either high powered or multi-shots with magazines that could not accommodate the length of the Polymag, I was limited in when I could use them. But last January while at the SHOT Show I stopped by to visit with Dick Dixon, who heads up Predator International, which is also the importer of JSB pellets. Every year I stop by to see what new products are coming to market, and thisRead More →